![]() Most people's hearing wouldn't go anywhere nearly as high as 17000 Hz anyway.Īpparently these are the default low pass filter frequencies.Īll that's probably quite academic though, because I think Vidcoder only encodes in constant bitrate mode (could be wrong as I don't use it) and I doubt it'd let you specify a different low pass filter frequency. You can probably change it too, but unless you're using a fairly high bitrate it wouldn't be a good idea. AES digital cross-over snake d sub to d sub (25 pin) 6 ft Tascam pinout. In constant bitrate mode the default low pass frequency for any decent bitrate is 17000 Hz. Other features include overdub mode, variable speed playback, limiting and low cut filter, and much more all with TASCAMs simple-to-use interface. I'd only use either of those modes but I found specifying a 18500 Hz low pass filter for mode 4 seemed to make the bitrate difference more balanced. I found in VBR mode there's quite a bitrate jump between mode 4 and mode 5. In the highest quality VBR mode, no high pass filter is used. Well in variable bitrate mode the default low pass filter frequencies might be a bit more aggressive than other encoders, but you can specify whatever low pass filter you like. However, this is done by "stealing" bits from higher frequencies that most people can't hear, but some can. As for the quality, it is true that FDK tries to use as much bits as it can to encode lower frequencies which can result in a better sound to most people.
0 Comments
Leave a Reply. |